This Fuel Injector set is a Bosch Replacement for the poor quality Chinese fuel injector Part Number MIA11720 used in any model year John Deere 825i Gator. Our Price is for All 3 Fuel Injectors! Please read the article below for more information – This content was provided by one of our customers who installed these in his John Deere Gator – You may find it helpful. I ended up doing this last night so I had to use what I had on hand to shim up the fuel rail. It’s not pretty, but it works. You can see there are 2 bolts that hold on the fuel rail (M8’s I believe). I had some 1/2” longer than the originals. I had to do away with the fuel injector clips, as the originals didn’t work on the new injectors. These clips just hold the injector onto the fuel rail when removing the fuel rail, did not appear to be 100% necessary to have them. The base of the fuel rail only needed to lifted about 5-6mm for the new injectors. This is partially because the new injectors could slide further up into the fuel rail because there were no clips. Here are the photos of the old injectors and how they were installed. Here are some photos of the new ones installed. If you look close, you can see I used 3 small washers to lift the fuel rail approximately 5mm. The bolts I had ended being a little too long, so I had to use an oversized hex nut at the top as a spacer or bushing so I could tighten everything up. As far as performance before installing these injectors, this gator would not start when hot, it would be flooded and have to sit for an hour or so before you could start it again. It would barely start when cold. It would idle very poorly and ran poorly as well. Misfiring, cutting out, you name it with the OE injectors. After Installing Your Bosch Injectors, First startup was rough for about 5 seconds as I suspect the computer had to readjust for the new injectors, then it smoothed out and idled perfectly. Which it hasn’t done in at least 7 months of being in and out of the shop. I took it for a test drive and it drove smoother than it has since it was new, and possibly stronger too. After driving it for a bit, I shut it off and it fired right back up! No flooding or hard start when it was hot. I’m hoping this has solved my problems, it’s looking good so far! Again, I appreciate your help. Common symptoms of Injector problems with John Deere Gators. Hard Starting – due to leaking injector. Rough Idle – caused by poor spray pattern or internal coil failure within the injector. Raw Fuel Odor – caused by uneven flow rates (dirty injectors). We have spent many hours in research to assure that these parts will be a perfect substitute for the poor quality Injectors used in these Chery Motors. Our Bosch injectors have the same flow rate, coil resistance, and plug connector as the original. MIA11720 Injector, so your gator will run as well as it did when it was brand new. Our Bosch injectors will be 1/2 inch longer than your OE Chinese made injectors, so before you install our injectors you will have to add washers under the fuel rail and use slightly longer boltsthat hold the fuel rail down, this will raise the rail 1/2 inch to allow these to fit. There is plenty of room above the rail to raise it. We reserve the right to repair the defective fuel injector. No allowance will be given for labor, installation costs, or damage claims. New fuel injectors that have been installed are not returnable. The item “New Bosch Fuel Injector Set (3) John Deere Gator 825i OE Alternative MIA11720″ is in sale since Wednesday, November 6, 2019. This item is in the category “eBay Motors\Parts & Accessories\ATV, Side-by-Side & UTV Parts & Accessories\Intake & Fuel Systems\Fuel Jets & Injectors”. The seller is “fuelinjectorman” and is located in Weidman, Michigan. This item can be shipped to United States, Canada.

• Modified Item: No
• Country/Region of Manufacture: United States
• Custom Bundle: No
• Fits: UTV
• Manufacturer Part Number: MIA11720
• Brand: Bosch
• Non-Domestic Product: No
• Warranty: Yes